Ayce J1X-SM01A-216 Traduction De La Notice Originale page 119

• Secure the workpiece with the clamping device (8) on the fixed saw table (16) to
prevent the material from moving during the cutting operation.
• Push down the release lever (3) to release the machine head (5)
Operating the saw
• Press the ON/OFF switch (2) to start the motor.
• With the drag guide (23) fixed in place:
use the handle (1) to move the machine head (5) steadily and with light pressure
downwards until the saw blade (7) has completely cut through the work piece.
• With the drag guide (23) not fixed in place:
pull the machine head (5) all the way to the front. Lower the handle (1) to the very
bottom by applying steady and light downward pressure. Now push the machine
head (5) slowly and steadily to the very back until the saw blade (7) has completely
cut through the work piece.
• When the cutting operation is completed, move the machine head (5) back to its
upper (home) position and release the ON/OFF button (2).
Attention! The machine executes an upward stroke automatically
due to the return spring, i.e. do not release the handle (6) after
!
completing the cut; instead allow the machine head to move upwards
slowly whilst applying light counter pressure.
WARNING
28
16 14
17
7
16
13
GB
118 | 119
29