Ayce J1X-SM01A-216 Traduction De La Notice Originale page 118

28
16
18
23
Cross cut 90° and turntable 0°
In the case of cutting widths up to approx. 100 mm it is possible to fix the traction
function of the saw with the set screw (23) in the rear position. In this position the
machine can be operated in cross cutting mode. If the cutting width is over 100 mm
then it is necessary to ensure that the set screw (23) is loose and the machine head
(5) can move. Attention! For 90° mitre cuts, the moveable stop rail (3) must be fixed
in the inner position.
• Open the set screw (29) on the moveable stop rail (28) and push the moveable stop
rail (28) inwards.
• The moveable stop rail (28) must be locked in a position far enough from the inner
position that the distance between the stop rail (28) and the saw blade (7) is no
more than 5 mm.
• Before making the cut, check that no collision could occur between the stop rail
(28) and the saw blade (7).
• Tighten the set screw (29) again.
• Move the machine head (5) to its upper position.
• Use the handle (1) to push back the machine head (5) and fix it in this position if
required (dependent on the cutting width).
• Place the piece of wood to be cut at the stop rail (18) and on the turntable (16).
1
5
7
29
2
3
8