Kärcher SC 3 Upright EasyFix Mode D'emploi page 15

Keep the device safe
ATTENTION
Material damage due to condensate/
moisture
The floor covering can be damaged by
moisture remaining on the floor clean-
ing cloth or floor nozzle/device after
cleaning.
Remove the floor cleaning cloth/carpet
glider and dry the floor nozzle/the de-
vice after finishing the floor cleaning
work.
Do not place or store the device on
heat-sensitive surfaces.
1. Remove the floor cleaning cloth or
floor cleaning cloth and carpet glid-
er, see the chapter "Floor nozzle
and carpet glider".
2.
1.
2.
1.
2. Remove moisture from the floor noz-
zle/device.
3. Wind the power cable around the
upper and lower cable holders.
4. Store the device in vertical position
on a solid base or on the wall.
5. Store the device in a dry location
that is protected from frost.
Important application
instructions
Cleaning the floor areas
We recommend sweeping the floor or
vacuum cleaning it before using the
device. In this way the floor will be
cleared of dirt and loose particles be-
fore the wet cleaning commences.
English 15