Quick Start - Home Skinovations Silk'n Flash&Go Mode D'emploi

Quick Start

Plan your Silk'n Flash&Go™ hair removal for best results!
Treatments 1-4 – plan two weeks apart
Treatments 5-7 – plan four weeks apart
Treatments 8 + – treat as needed, until desired results are achieved.
Set up Silk'n Flash&Go™!
1. Remove Silk'n Flash&Go™ HAIR REMOVAL UNIT and other components from box.
2. Verify that the DISPOSABLE LAMP CARTRIDGE is inserted properly at the tip of the device.
3. Plug the ADAPTOR cord into the Silk'n Flash&Go™ HAIR REMOVAL UNIT socket.
4. Plug the ADAPTOR into an electrical outlet. The STAND BY INDICATOR LIGHT will turn on.
Your Silk'n Flash&Go™ is now ready to start.
Treat with Silk'n Flash&Go™ safely and properly!
5. Choose areas to treat that have not had recent exposure to the sun.
6. The skin of the treatment areas should be shaved, clean, dry and free of any powders, antiperspirants
or deodorants. Do not wax, pluck or tweeze the hair out.
Shaving is an important step to get the results you want!
7. Press the ON/STBY SWITCH. The POWER ON INDICATOR LIGHT (orange) will turn on and
a fan sound (similar to the sound of a hairdryer) will start.
8. Approximately 3.5 seconds after pressing the ON/ STBY SWITCH, the READY INDICATOR LIGHT
(green) will turn on. The device is then ready for you to trigger the first pulse at the lowest
energy level.
9. If this is your first treatment - Choose the energy level. Flash&Go offers 5 levels of energy from
1(the lowest) to 5 (the highest). To choose the right energy level for your first treatment, test each
treatment area separately:
Skin Test
Place the TREATMENT SURFACE on the skin and press the trigger to deliver one pulse.
If you did not experience abnormal discomfort press the + button once and deliver one pulse on a
different spot at energy level 2.
Continue testing at increased energy levels until you have reached the highest level that you feel
comfortable with. If within one hour you experience no adverse effects, you can start your full
treatment at that energy level.
Repeat this test for each body part you intend to treat.
1