shark Rotator Powered Lift-Away ZU630 Série Guide De L'utilisateur page 4

WHOLE-HOME CLEANING
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
s h a r kc l e a n . c o m
SETTINGS
Press the Power button to turn the
vacuum on or off.
Slide the selector switch to the
appropriate surface setting:
For thick carpets and area rugs:
Set switch to Thick Carpet/Area Rug.
For cleaning low-pile carpets:
Set switch to Carpet/Low Pile to
increase the speed of the brushroll to
remove stuck-on dust and debris.
For bare floors or above-floor areas:
Set switch to Hard Floor.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt
in carpets) please set to Carpet/Low Pile.
WHAT DOES THE BRUSHROLL INDICATOR
LIGHT MEAN?
Solid Green: The brushroll is spinning and
working as it should.
Solid Red: There is a jam in the brushroll
area. Turn your vacuum off and remove
any blockages.
Flashing Red*: The motorized floor nozzle is
overheating. Turn your vacuum off and wait
45 minutes for it to cool down.
* See Troubleshooting section for further
instructions.
WHOLE-HOME CLEANING
CLEANING MODES
UPRIGHT
To engage brushroll, turn power on, select a
surface setting, then step on floor nozzle and
tilt handle back.
ABOVE-FLOOR
Press the Handle Release Button to detach
the handle to clean above-floor areas. Insert
accessories directly into handle.
LIFT-AWAY®
Press Lift-Away Button to lift pod off
motorized floor nozzle. You are now ready to
clean those hard-to-reach places.
Wand
Release
ABOVE-FLOOR—EXTENDED REACH
Press the Wand Release Button to detach
the wand to clean with more reach. Insert
accessories directly into wand.
s h a r kc l e a n . c o m