shark Rotator Powered Lift-Away ZU630 Série Guide De L'utilisateur page 6

CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow
all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being
drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam Filter
Filter Frame
Felt Filter
Pre-Motor (foam and felt):
With the dust cup removed, take out the
foam and felt filters and rinse them with
water only. Tap loose dirt off filters between
washes as needed.
CLEAN PRE-MOTOR FILTERS EVERY
3 MONTHS.
REPLACING FILTERS
Follow the previous instructions for removing filters. The pre-motor filters should be replaced every
2.5 years. The post-motor HEPA filter should be replaced every 3 years.
Replacement Replacement
HEPA Filter
Pre-Motor Foam &
XHF632
Felt Filter Kit
XFFK632
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
s h a r kc l e a n . c o m
HEPA
Post-Motor (HEPA):
To access the HEPA Filter, pull the latch
under the filter cover and take off the cover.
Remove the HEPA filter and rinse it with
water only.
CLEAN HEPA FILTER EVERY YEAR.
CHECKING FOR BLOCKAGES & MAINTAINING BRUSHROLL
Self-Cleaning Brushroll
The self-cleaning brushroll automatically removes hair wrap. If some hair or debris remains after
continued use, remove the cover to access the brushroll.
Using a coin, turn locks counterclockwise, then open the cover to access Brushroll.
NOTE: Cover will open but is not completely removable.
DEBRIS WRAPPED AROUND BRUSHROLL
Clean off any debris on the bristles.
NOTE: If any hair is wrapped around the brushroll,
extending cleaning time will allow the self-cleaning
brushroll to remove it for you. If some fibers remain
wrapped around brushroll after continued use, carefully
cut debris with scissors and remove from brushroll.
DEBRIS BEHIND BRUSHROLL
If you vacuum up a hard or sharp object or
notice a noise change while vacuuming, check
for blockages or objects caught in the brushroll.
Clear away any dust, dirt, or blockages in
Debris Intake.
To close the cover, push down until it clicks
into place, then close the locks with a coin.
s h a r kc l e a n . c o m