Overview Of The Components; Using Your Coffee Maker - HAEGER CM-68B.007A Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Overview of the components

1. Water tank lid
3. Funnel (Swing-out filter)
5. Water container
7. Glass carafe with lid
9. ON/OFF button
Before First Use
This appliance is designed to brew drip coffee by the effect of hot water
passing through ground coffee.
Completely remove all the transport and packaging items inside or outside
the appliance.
Clean the jar and filter housing and permanent filter.
Put the appliance on a flat and stable surface.
Put the plug in an earthed wall socket.
Open the lid and fill the water tank with fresh, cold water to the maximum
indication and put the jug in place.
Do not put a filter with ground coffee in the filter basket.
Switch the appliance on by pressing the on/off switch the coffee maker
will start working and the pilot light will light on.
Let the appliance run until the water tank is completely empty.
Switch the appliance off when all the water is in the jar. The pilot light will
go off to indicate that the coffee maker has been switched off.
Let the appliance cool down for at least 4 minutes before you start
brewing coffee.

Using your coffee maker

1. To prepare Coffee or Tea: Take a standard 1X4 paper filter and put into the
filter basket then add necessary amount of ground coffee (approx. 7g per
cup) or Tea. Insert the filter assembly into position. Fill up the water tank
with required quantity of fresh and cold water, close the lid and place the
jug on the hotplate. Turn on by pressing the switch, the appliance starts
working.
2. Anti-drip function: The drip stop system prevents coffee from dripping
through the filter onto the hotplate when you remove the jug from the
appliance during or after brewing. To prevent overflow from filter, never
4
2.
Top cover
4.
Water level indicator
6.
Main housing
8.
Bottom cover
Instructions for use

Publicité

Table des Matières
loading

Table des Matières