Overview of the components
1. ON/OFF switch
3. Steam switch
5. Green lamp
7. Water tank cover
9. Top cover
11. Froth device
13. Bottom cover
15. Removable shelf
17. Measuring spoon and tamper
19. Filter handle
Before The First Use
To ensure the first cup of coffee tastes excellent, you should rinse the coffee
maker with warm water as follows:
1.
Open the tank cover and pour water into it, the water level should not
exceed the "MAX" mark in the tank. Then close the water tank cover.
Note: The appliance is supplied with a detachable tank for easy
cleaning, you can fill the tank with water firstly, and then put the tank
into the appliance.
2. Set filter into filter holder (no coffee powder in filter). Make sure the handle of
the filter holder aligns with groove in the appliance, then insert the filter
holder into the appliance from the "INSERT" position and fix them into coffee
maker firmly through turn it anticlockwise until it is at the "LOCK" position.
3. Place a jug on removable shelf. Make sure the steam control knob is
switched "OFF" or in "0" position.
Note: The appliance is not equipped with jug, please use yourself jug or
coffee cup.
4. Connect to power source, turn the ON/OFF switch to the "1" position. The
power red indicator will be illuminated.
5. Keeping the steam switch to the "0" position and switching the coffee/hot
water selector to the "1" position the pump will pump water. When there is
water flowing out pressing the coffee/hot water selector to the "0" position
and waiting for a moment, the appliance begins to be pre-heated until the
green lamp is illuminated, it shows the pre-heating is finish. Pressing
coffee/hot water selector to the "1" position again, the water will flow out.
6. After water not dropping out any more, you can start brewing.
Instructions for use
2.
Coffee/Hot water selector
4.
Power red indicator
6.
Steam control knob
8.
Water tank
10. Steam wand
12. Main body
14. Drip tray
16. Stainless steel filter
18. Filter holder
20. Filter lock bar
English
3