Bartscher 110.134 Mode D'emploi page 31

Digital temperature regulator
Display and functions
Primary temperature settings are established at the factory and correspond to a working
temperature in the device of approx. 2° -10° C.
During normal use, the display will show the temperature as measured by the sensor.
The LED will also show the current state of functions (table 1), and by using the 3 buttons
some functions can be activated/deactivated (table 2).
LED Function
①
Compressor On
②
Ventilator
③
Defrost
④
Aux
⑤
Time
⑥
Alarm
Digital
⑦
display
- 30 -
Normal working mode
ON OFF
Off
On Off
On Off
Device is on Device is off
RTC function RTC function is
is available not available or
and/or active turned off, or no
and set for at time period has
least 1 time been set
period
All No alarm
Composed of 3 lighted values with comma/period and
range of -199...999. See parameters /4, /5, /6 for the
display of values detected by sensor, values in ° C/ ° F and
after the comma/period
Start
Flashing
Needed ON
Needed ON
Needed ON
-
ON
- ON, if the
RTC
function
is
available
- ON
Tab. 1