SpeedEPart Agri Fab 45-03503 Manuel Du Propriétaire page 6

16. Place the latch lock lever through the slot in the
tongue. Insert the 5/16" x 4" hex bolt (A) through one
side of the tongue. Assemble a (SEMS) hex nut (G),
the lever and another (SEMS) hex nut (G) onto the
hex bolt. Insert the hex bolt through the opposite side
of the tongue and assemble a 5/16" nylock nut (J)
onto the end of the hex bolt. Tighten so that the hex
bolt can still rotate freely. Tighten the two (SEMS) hex
nuts (G) against each side of the latch lock lever so
that it is centered in the slot. See figure 8.
LATCH LOCK LEVER
5/16" x 4"
HEX BOLT (A)
FIGURE 8
17. Hook the short end of the spring (O) into the hole in
the latch lock lever. Use the spring puller tool (V) to
hook the long end of the spring into the square hole
in the tongue. The spring puller tool (V) can be stored
when finished. See figure 9.
SPRING PULLER
TOOL (V)
FIGURE 9
5/16" SEMS NUTS (G)
LATCH
LOCK
LEVER
5/16"
NYLOCK
NUT (J)
LONG END
OF SPRING (O)
LATCH LOCK LEVER
18. Assemble the end of the hitch bracket (two holes) up
through the slot at the front of the drawbar tongue.
Fasten it to the tongue using the 3/8" x 1" hex bolt (C)
and 3/8" nylock nut (I). Tighten. See figure 10.
19. Assemble the hitch pin (S) through the hitch bracket
and the tongue and secure it with the 1/8" hair cotter
pin (Q). See figure 10.
3/8" x 1"
HEX BOLT (C)
HITCH
BRACKET
FIGURE 10
20. Assemble a 1" thin washer (M), a walking beam and
another 1" thin washer (M) onto the pivot axle. Insert
a cotter pin (P) into the axle and spread the ends.
Press a hub cap (W) onto the flat washer. Repeat on
the other end of the pivot axle. See figure 11.
NOTE: Eight extra 1" flat washers are provided to take up
end play if necessary.
1" THIN WASHER (M)
1/8" x 1-1/2"
COTTER PIN (P)
HUB CAP (W)
FIGURE 11
6
1/8" HAIR
COTTER
3/8" NYLOCK
PIN (Q)
NUT (I)
HITCH PIN (S)
WALKING BEAM