SpeedEPart Agri Fab 45-03503 Manuel Du Propriétaire page 5

9. Assemble the front panel over the end of the cart
using six 1/4" x 5/8" (F) hex bolts and 1/4" nylock
nuts (H) as shown in figure 4. Leave two holes in the
bottom of the panel empty as shown. Pull the cart
body halves together and tighten the bolts in the
bottom of the front panel, then tighten the bolts in the
sides. See figure 4.
10. Tighten the bolts assembled in step 4 to fasten the
bottom of the cart together.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" NYLOCK NUT (H)
FIGURE 4
11. Assemble the latch stand bracket to the cart so that
the aligning tab is at the bottom of the bracket. Use
four 1/4" x 5/8" hex bolts (F) and 1/4" nylock nuts (H).
Tighten. See figure 5.
12. Assemble a corner cap to each front corner using
one 1/4" x 5/8" hex bolt (F) and 1/4" nylock nut (H)
per cap. TIGHTEN. See figure 5.
HEX BOLT (F)
1/4" NYLOCK
NUT (H)
1/4" NYLOCK
LATCH STAND BRACKET
(Aligning tab at bottom)
FIGURE 5
1/4" x 5/8"
HEX BOLTS (F)
1/4" NYLOCK
NUT (H)
1/4" x 5/8"
1/4" x 5/8"
HEX BOLT (F)
CORNER
CAP
NUT (H)
13. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts (D) and 5/16" nylock
nuts (J) as shown in figure 6. Heads of bolts go on
the inside of the cart. Tighten.
WHEEL
SUPPORT
5/16"
NYLOCK
NUT (J)
FIGURE 6
14. Lower the cart to rest upside down on its top flange
with the wheel support facing up. See figure 7.
15. Lay the drawbar tongue (open side facing up) onto
the Wheel Support and the Latch Stand Bracket.
Slide the axle through the wheel support and the
tongue. See figure 7.
FIGURE 7
5
5/16" x 3/4" TRUSS
HEAD BOLT (D)
AXLE
DRAW BAR
TONGUE
LATCH STAND
BRACKET