Instructions For The Installer - Zanussi ZFT 710 W Notice D'utilisation

Instructions for the Installer

Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/day)
Energy class, according to EU Standards
Freezing capacity (kg/24h)
Rising time (h)
Rated power (A)
Weight (kg)
Transportation, unpacking
It isrecommended to deliver the appliance in
original packaging, in vertical position consid-
ering the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 4 hours.
Unpack the appliance and check if there are dam-
ages on it. Report possible damages immediately to
the place you bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts
not to move in the appliance.
Wash the inside of the appliance using lukewarm
water and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practi-
cal to operate the appliance between ambient tem-
perature limits according to the climate class that is
given in the chart below and can be found in the data
label.
38
(kWh/year)
ZFT 710 W
110
91
550
850
612
0,504
184
A+
12
22
0,8
39
Class of climate
SN
N
ST
T
If the ambient temperature goes below the lower data
the temperature of the cooling compartment can go
beyond the prescribed temperature.
If the ambient temperature goes beyond the upper
data this means longer operating time of the compres-
sor, increasing temperature in the freezer or increas-
ing energy consumption.
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the
bottom in front. 1-1 piece of distance washers (2) are
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+16 ... + 38 °C
+16 ... + 43 °C