Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Procedure for a Dual Fuel
Slide-In Range (HDI8054,
HDIP054 ranges only)
Tools Needed
•
Torx T20 screwdriver
•
gloves
Preparation
IMPORTANT!
Can the range slide out enough to have access to the rear
and side trim screws? See Figure 1: Trim Screws, Dual
Fuel Range.
•
If the range can slide out, go to the Procedure.
•
If the range cannot out, contact a qualified service
person to disconnect the gas or electrical connections
that prevent the range from being pulled out before
continuing to the Procedure.
•
Read the Tip Over Warning in the Safety section of this
manual. Be aware of this hazard when the range has
been pulled out for this installation.
Procedure
1. Confirm that the range surfaces and cooktop grates are
cool enough to be comfortably touched.
2. Slide the range out enough to access the trim mounting
screws (see Figure 1: Trim Screws, Dual Fuel Range).
Figure 1: Trim Screws, Dual Fuel Range
3. Remove the cooktop grates.
4. Remove the screws holding the trim (five screws on the
back and one screw on each end). Save the screws for
installing the Island Trim (see Figure 1: Trim Screws,
Dual Fuel Range).
5. Lift the trim up to remove.
6. Lower the Island Trim into place, aligning the Island
Trim hole 1 with the hole at 2 on both sides of the
range. See Figure 2: Island Trim placement.
9001040675 Rev B
Figure 2: Island Trim placement
7. Secure the Island Trim with one screw at each end and
five screws in the back. See Figure 1: Trim Screws,
Dual Fuel Range.
8. Replace the cooktop grates back into their normal
positions,
Figure 3: New Island Trim Installed
9. If necessary, have a qualified service person reattach
electrical or gas connections.
10. Slide the range back into position, being sure to
engage the anti-tip bracket. See the Tip Over Hazard
Warning earlier in this instruction and also in the Slide-
In Range Installation Manual.
English 5
Publicité
Table des Matières
