Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation page 64

Problem
No reaction from
transmitter after
changing batteries.
BATTERY appears on
the display.
Desired drive is not
functioning.
Sun protection does
not travel to end po‐
sition.
Automatic drive
commands are not
executed.
64
Cause
Receiver out of radio
range.
Transmitter is not
programmed in re‐
ceiver.
Power supply was in‐
terrupted for too
long.
Batteries are weak.
Incorrect channel
selected.
End position not set.
"MANUAL" appears
on the display
Winter setting is set
to ON.
The automatic sun
protection function
was interrupted by a
manual drive com‐
mand.
Remedy
Reduce distance
from receiver.
Program transmitter.
Press the RESET
button.
Check the settings.
Insert new batteries.
Select correct chan‐
nel.
Set the end position
in the settings menu
SUN END POSITION
or TIME END POSI‐
TION.
Set the slide switch
to the opposite posi‐
tion.
Set winter setting to
OFF.
Set the slide switch
to the opposite posi‐
tion and back again.