Functional Description - Lehmannaudio Black Cube SE II Mode D'emploi

38 Black Cube SE II

Functional description

EN
In this chapter you will learn more about the connections,
controls and also the application possibilities of your
Lehmannaudio Black Cube SE II phono stage.
Front panel
1
1 | Operating mode display (LED)
When the LED is lit up, the Black Cube SE II is operational. The device does not
have a power switch.
Rear panel
2
4 5
2 | Ground terminal (GND)
If your record player has a separate ground cable, please connect it here. The
terminal is suitable for connecting a cable, flex, open cable ends, cable lug or
4 mm banana plug.
3 | Grommet for the PWX power supply
The four-pin Neutrik XLR connector is plugged into the enclosed power supply.
Please do never pull off or plug in this connection during operation.
4 + 6 | Output jacks (OUT)
RIAA filtered high-level output. Connect the cables that either lead to the input
of a downstream high-level pre-amplifier (high-level inputs are labelled 'Line',
'AUX', 'CD', 'Tuner' etc.) or directly to a power amplifier with volume control. The
left jack (black) is for the left channel, the right jack (red) for the right channel.
Please be sure to connect the channels correctly.
Black Cube SE II
3
6 7
39
EN