Technical Specifications - Lehmannaudio Black Cube SE II Mode D'emploi

48 Black Cube SE II

Technical specifications

EN
Sensitivity for output level
775 mV/ 0 dB
(with activated high gain switch)
Gain 1 kHz
Maximum input level
Signal to noise ratio
(RMS unweighted)
Gain
Channel separation
Input impedance
Output impedance
Input capacitance
Channel mismatch
Bass filter
Power consumption
Mains voltage
Fuse
MM MC
3.8 mV/1 kHz 0.38 mV/1 kHz
46 dB 66 dB
45 mV 4.5 mV
71 dB 63 dB
36 dB, 46 dB, 56 dB, 66 dB
> 80 dB at 10 kHz
47 kohms, 1 kohm, 100 ohms
1 x custom load
≠
1 x Hardwire slot
≠
47 ohms
100 pF
typ. 0.5 dB
16 settings between 7 Hz and app. 90 Hz
< 3 W
Europe: 240 V AC
≠
USA/Canada/Mexico/Taiwan: 120 V AC
≠
Europe: 250 mA Slow
≠
USA/Canada/Mexico/Taiwan: 500 mA
≠
Slow
Outer dimensions W x D x H
Weight
Troubleshooting
Fault Cause
LED indicator is The mains cable is not
not lit. plugged in at the power
outlet.
The power supply is not
connected with the device.
No signal. The mains cable is not
plugged in at the power
outlet.
The power supply is not
connected with the device.
Input and output are not
wired correctly on the
Black Cube SE II.
A wrong input channel
has been selected on the
following amplifier.
Black Cube SE II
Audio section: 114 mm x 124 mm 50 mm
≠
PWX power supply:
≠
93 mm x 233 mm x 45 mm
Audio section: 0.6 kg netto
≠
PWX power supply: 1.0 kg netto
≠
Solution
Insert the mains cable into the
power outlet.
Connect the power supply with
the device.
Insert the mains cable into the
power outlet.
Connect the power supply with
the device.
Check if the cables coming
from the turntable are con-
nected to the input and also
if those going out to the amp
are connected to the output of
the Black Cube SE II. Reconnect
them correctly if necessary.
Select the appropriate input
channel.
49
EN