Brief Instruction; Functional Description - Lehmannaudio Traveller Mode D'emploi

36 Traveller

Brief instruction

EN
The Traveller is operated using the two buttons on the front of
the device.
1 | Powering up
Press the plus button for more than three seconds. After you release the button,
a LED lights up. The Traveller switches to operating mode and the volume slowly
increases to the last value before it was shut off.
2 | Volume
The volume is controlled intuitively using the two buttons. Pushing the plus button
increases the volume, pushing the minus button decreases the volume. If you push
and hold one of the buttons, the volume changes more quickly.
3 | Switching off
Push both buttons until the LEDs on the right and left light up. Continue holding the
buttons until the Traveller switches to standby mode after five seconds. The device
settings are stored as long as energy is supplied by the battery.
ATTENTION!
Headphones can reach volumes that are hazardous to health.
Before putting on your headphones, always verify that the
volume setting is not too high!
Further information on the allowable exposure times depending on
sound pressure levels (dBA) according to the Occupational Safety
Directive is found on page 33.

Functional description

This section tells you about the connections, control elements
and application possibilities of your Lehmannaudio Traveller
headphone amplifier.
Front
1 2
1 | Front headphone output
Mini stereo jack (3.5 mm) for headphones with a corresponding plug: Connect
your headphones or active speakers here. Headphones with a large stereo plug
(6.35 mm) can be connected with an adapter. The headphone jacks on the front
and rear are interconnected. You can connect a second set of headphones or
active speakers. The level is identical on both outputs.
Traveller
4 3
37
EN