LEXIBOOK DJ053 Série Mode D'emploi page 33

Q: My camera doesn't turn on when I press the POWER button. What do I do?
A:
1. Check that you have installed the batteries correctly.
2. Place new batteries or fully recharged batteries in your camera.
Q: I can't see the LCD screen. What do I do?
A:
1. Your camera may have gone into power saving mode. Press POWER and see if
it turns on.
2. Your batteries may be low. Place new batteries or fully recharged batteries in
your camera.
3. Check that you have installed the batteries correctly.
Q: Why does nothing happen when I press the SHUTTER button?
A:
1. The camera may be still be doing a previous action such as recharging the flash,
saving, copying or erasing a photo. Wait a few seconds and try again.
2. The camera's SD card memory may be full. If this is the case, you need to delete
photos from your camera. Make sure you transfer any photos you want to keep
to your computer first.
3. The timer may be counting down wait a few seconds.
Q: Why are my pictures unclear?
A:
1. The lens may be dirty. Gently blow any loose dust from the lens. Then breathe
gently on the lens and wipe it with a soft, clean cloth that has no chemicals on it.
2. Make sure you hold the camera steady until after the red LED light has gone out.
3. You may be too close to your subject. Try moving further away.
Q: Why are my pictures too dark?
A:
1. The flash may be turned off. See the 'Taking Photos' section for how to set the
flash.
TROUBLESHOOTING
33