Connection Of The Stove To The Chimney - Saey ePure Guide D'installation Et D'utilisation

• From the side walls of the stove:
• From the rear: rear connection
• From the rear: top connection
• Within the radiation range of the glass:
• Floor protection in front of the appliance:
• Floor protection at the sides:
In order to be able to install the stove levelly, adjustable feed have been foreseen. Adjust these when
necessary so the stove is positioned as flat as possible.

7. Connection of the stove to the chimney

The stove can be connected directly to the chimney (outlet at the back). The diameter of the outlet duct
must correspond with the 150mm diameter of the stove's outlet connector.
If the draught of the chimney is too strong (> 20/22 Pa), a draught regulator must be built in.
You must also take the following into account with regard to the diameter of the outlet duct:
• The diameter of the outlet duct may not be reduced. In addition, the outlet duct must fit perfectly onto the
chimney.
• The stove duct may not be smaller than the diameter of the chimney, since this will hamper the upward
pressure of the fumes. In order to prevent this, you should provide a double wall lining.
53
at least 30 cm
at least 20 cm
at least 20 cm
at least 80 cm
at least 50 cm
at least 30 cm