Publicité
Lighting the Grill
•
Any of the Burners can be lit first using the Pulse Ignitor/ Match. It is upto the customer
preference and requirement.
•
If Burners does not light or flame is too low, you may have spider or other insect blockage
inside or vicinity of the burner holes. See "Replace the Burners" section.
•
The IR burner (sear burner) lighting process is similar to that of Main Burners.
Method 1 (Using Pulse Ignitor Button):
1. Read and complete PRE-GRILL checklist.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the "OFF" position.
4. Turn the control knob for the Burner to the "HIGH" position.
5. Press the Pulse Ignitor button and hold for 3–5 seconds to light burner.
6. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn
off the gas flow from the cylinder.
8. Once the grill is lit, adjust the temperature using the Max -to- Min settings.
High
Temperature
40
NOTES
Low
Temperature
Pulse Ignitor
Publicité
