Publicité
Installing Grill on custom built cabinet
Layout for Non-combustible enclosure
Configuration Example 2: With open cutout bottom
Note:
Avoid abrasion of hose against the
opening. It is recommended to use a rubber
grommet at the opening.
Rubber grommet
2.375" Dia
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED ON EACH END OF
CABINET.
5"
127mm
MAXIMUM
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED.
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED
NOTE: These illustrations are for reference purpose
only. Actual built-in cabinets and installation may
differ.
18
10in
1in
Back View
H
1"
PARTITION TO ISOLATE
25.4mm
CYLINDER FROM GRILL
MAXIMUM
Note: The cabinet should not be designed in a
way that a spare cylinder can be stored inside the
enclosure.
The opening of propane enclosure is limited to the
dimensions below:
Width (W1) must be less than 23.5".
10in
Height (H1) must be less than 18.5".
Propane tank must be secured to the built-in cabinet
inside the cylinder enclosure.
D
W
H1
W1
Publicité
