Setting The Time - Indel B FLYINGBAR 115V Mode D'emploi

FLYING BAR 11 5V
S E T TIN G THE TIM E
If you press any button from P1 to P4 several times, the display will show the chosen pro-
gramme and then the time.
To set the time, press P2 and P3 at the same time. The hour digits will start to flash and the
display will show the words "set time".
Press - (P2) and + (P3) to set the right time.
To set the minutes, press P1 and then - (P2) and + (P3).
Press P4 to save the new time setting. The display will
show the current time.
To set a programme (P1, P2, P3 or P4) on the Minibar, press
the button of the chosen programme for at least 2 seconds.
If the batteries have run out, the display will show this
symbol:
Press ON/OFF to turn the Minibar off. The display will show
"Off". To enable the remote control again, press the ON/OFF
key.
WARNING!
If the mains power supply is cut off for less than 48 hours, the Minibar turns on again using
the previously set program. If the mains power supply is cut off for more than 48 hours, the
Minibar will be operated by the pre-calibrated thermostat. To set a program again, follow the
instructions given on THE REMOTE CONTROL.
WARNING!
If the power supply is voluntarily cut off, wait at least 15 minutes before turning the refrigerator
on again (i.e. before connecting it to mains supply). If not, the compressor could be locked for
few minutes before starting its normal operating.
FLYINGBAR 115V_05-06-2020
18
SET TIME
TIME
OFF