Publicité
10 Manual time setting
To set the time/date manually, first check whether the radio symbol in the display is still flashing (auto-
matic reception of the time signal is then still active). If the radio symbol is still flashing, press the
DOWN button for 3 seconds to deactivate reception.
1. Press the SET button for approx. 3 seconds to enter the time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the SET button to confirm and switch to the next setting.
5. Sequence of the settings: Time offset (+/- 12 hours) > hours > minutes > year > month > day >
12/24 hour mode > Exit
6. Finally, press the SET button to save the settings and exit settings mode.
11 Alarm setting
Alarm time setting
1. In normal display mode, press SET button to switch to alarm time display (AL).
2. Press and hold SET button for approx. 3 seconds to enter alarm time setting mode.
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press SET button to confirm and continue to the next setting.
6. Settings order: hours > minutes
7. Finally press the SET button to save the settings and exit the setting mode.
Enable/disable alarm
8. In normal display mode, press SET button to switch to alarm time display (AL).
9. Press DOWN button to enable the alarm. The
10. Press DOWN button again to disable the alarm. The
12 Snooze function
1. When the alarm sounds, press the SNOOZE/LIGHT button to activate the snooze function. The
alarm sounds again after 5 minutes.
2. When the alarm sounds, press any other key to stop the alarm until the set alarm time is reached
again.
3. If no key is pressed, the alarm is automatically switched off after 2 minutes.
13 Display change
• In normal display mode, press the SET button to switch between time and alarm.
• In normal display mode, press the UP button to toggle between °C and °F when displaying the
temperature unit.
• In normal display mode, press the CHANNEL button for about 3 seconds to clear the outdoor
sensor data and reinitialize sensor reception.
• In normal display mode, press the Max/Min button several times to display the set Max/Min values
one after another.
• During the Max/Min display, press the Max/Min button for about 3 seconds to clear the Max/Min
data. Every day at 0:00 a.m. the max/min data record is automatically deleted.
22 / 52
symbol will be displayed.
symbol will disappear from the display.
Publicité
