Publicité
•
Wipe the fixed parts and the cups of the burners with a damp cloth and then
dry.
•
gently wipe the ignition device and flame monitoring with a well-wrung cloth
then dry with a dry cloth.
•
Before giving up the burners on the hob, make sure that the injector is not
blocked.
•
Reassemble the auxiliary burners, fast and as follows:
a. Place the flame diffuser (4) on the burner plate (5) so that the ignition
device and the security device passes through their respective holes in
the flame spreader. The flame spreader must engage correctly.
b. Position the burner cap (1, 2, 3) on the flame spreader so that the
retaining pins fit into their respective holes.
warnings
Put the pieces correctly in order after cleaning.
Do not mix the top and bottom parts.
The holding rods must exactly fit into the slots.
warnings
Do not modify the unit.
-
This device must be installed by a licensed technician or installer.
-
Before installing, make sure that the local distribution conditions (nature
-
of the gas and gas pressure) and the instrument setting are compatible.
The setting conditions for this unit are indicated on the label
-
(Or plate).
This device is not connected to a device for discharging products of
-
combustion. It must be installed and connected according to the
installation standards. Particular attention should be given to existing
standards for ventilation.
Before installation, turn off the gas and the electric power source of the
-
device.
2
1
3
4
5
6
7
44
2
3
4
7
6
5
Publicité
