Publicité
You must be a gap of at least 25 mm and at most 74 mm between the bottom of the
•
appliance and any surface that is below.
-
An oven must have a forced ventilation to install the plate above.
-
Check the dimensions of the oven in the installation guide.
-
The size of the cut must comply with directions
Bottom View
1. Remove utensils supports, burner caps and flame diffuser
and carefully turn the unit upside down by placing it on a
padded surface. Take care that the flame monitoring devices
are not damaged during this operation.
2. Apply adhesive seal provided on the edges of the device.
3. Do not let the gap filler agent and do not overlap the
thickness.
Do not use silicone glue to attach the device to the
work plan, this will make it difficult to remove the device
in the future, especially if it needs repair.
1. Place the binding (B) over the holes corresponding to the size
of the screws. There is a set of screws for the holes in each
corner of the plate (H).
lightly tighten a screw (C) through the holder (B) so that the
attachment is attached to the plate but so that the plate can be
further adjusted.
2. Replace the plate location and then lower it gently into the
opening you cut in your work plan.
3. On the plate, adjust the bindings to the appropriate position
for your work plan. Then fully tighten the screws (C) to secure
the hob.
34
Publicité
