HOMCOM 820-345V80 Guide D'installation page 9

B. Have two people hold the appliance against the wall to determine the final
location.
C. Place unit face down on a soft, non abrasive surface. Remove the bracket from
the back of the unit by removing the screws, refer to Figure 1.
D. Mark out location, then mount the bracket(s) onto the wall using the supplied
screws. This bracket MUST have the hooks facing upward and be level. NOTE: It
is strongly Recommended that the mounting bracket be screwed into the wall
studs where possible. If the wall studs cannot be used, ensure that the supplied
plastic anchors are used to affix the bracket to the wall and the bracket is
adequately secured.
E. With the wall mounting bracket installed have two people lift the appliance up and
insert the two hooks on the bracket into the two slots on the back of the appliance.
F. Mark the two bottom holes position, remove the heater ensuring that the bottom
fixing bracket is rotated up. Drill and fit wall plug.
G. Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket
down again and use the screw provided to permanently fix the heater in place.
H. Lock the screws on the side of the fireplace to permanently fix the heater with the
wall bracket.
9
820-345V80BK
820-345V81BK
820-345V82BK