HOMCOM 820-345V80 Guide D'installation page 10

Instructions for Use
WARNING: Read and understand this entire owner's manual, including all safety
information, before plugging in or using this product. Failure to do so could result in
electric shock, fire, serious injury, or death.
Methods of Operation
This electric fireplace can be operated by the SWITCH, located on the side of the
right cold air inlet, or by the battery-powered REMOTE CONTROL.
Manual Operation
The switches located on the side of the right cold air inlet. The standby switch must
be first switch on.
Press once the O/I button to turn on the appliance and fire effect. A red indicator light
will appear to indicate that the function is ON.
Press the 750W button once for the low heat settings; press twice to switch off the
heat setting.
Press the 1500W button once for the high heat settings; press twice to switch off the
heat setting.
Remote Operation
The standby switch located of the right cold air inlet must be first switch on.
It takes some time for the receiver to respond to the transmitter. Do not PRESS the
buttons more than once within two seconds for correct operation.
ON: Enables control panel
functions. Turn on flame
effect.
OFF: Disables control panel
functions. Turn off flame
effect, and the fireplace will
be in the standby status.
Timer button: Timer setting.
COLOR button: Makes the
color flame effect changing.
Temperature Setting button:
Makes the setting
temperature changing.
1. Press once. Indicator light
turns on. Power turns on. All
functions enabled.
2. Press again come into the
standby status
1. Press once. 1 hour timer
setting.
2. Press again until desired
timer is reached. Which is
from 0h to 8h.
1. Press once. Flame color
effect gets changing.
2. Press again until desired
color is reached.
The default set temperature is
83F, press "+" or "-" on the
remote controller to set the
temperature, which ranges from
59F to 88F.
10