Service Programmes - NEFF C1 KS61N0 Série Mode D'emploi

en

Service programmes

■ Push the brewing unit all the way into the
appliance and press on the middle until it
audibly clicks into place.
F
Important: The red latch must be
right over at the left at j before
replacing (see diagram E).
■ Press the eject lever right up and push
the red latch right over to the right to k.
■ Insert the coffee grounds container.
■ Replace the protective cover.
■ Close the appliance door.
Service programmes
(see also the Quick reference guide)
The following messages will appear on the
display at certain intervals, either
"Descaling programme urgently required!" or
"Cleaning programme urgently required!" or
"Calc'nClean programme urgently required!".
The unit should immediately be cleaned or
descaled using the appropriate programme.
Alternatively, the two processes Descale
and Clean can be carried out together using
the calc'nClean function (see the section
"Calc'nClean"). Failure to carry out the
service programme according to the instruc-
tions may damage the appliance.
F
Important: If the appliance is not
descaled when it is supposed to be,
the message "Descaling programme is
overdue. Device will shortly be locked."
will appear. Immediately perform the
descaling process in accordance
with the instructions. If the appliance
is locked, it can only be operated
again once the descaling process
has been carried out.
To display how many beverages can still
be prepared before one of the service
programmes needs to be run, proceed as
follows:
■ Touch E.
■ Select "Service info" with the K or L
arrow button.
■ Press M to call up the information.
46
A
Warning!
For each of the service programmes,
use descaling and cleaning agents
as described in the instructions
and observe the (relevant) safety
information.
Never interrupt a service programme.
Do not drink liquids!
Never use vinegar, citric acid or any
vinegar-based or citric acid-based
agents.
Never place descaling tablets or
other descaling materials in the
coffee drawer!
F
Important: Before starting each
service program (Descale, Clean or
Calc'nClean) remove the brewing unit,
clean as instructed and replace it.
Be careful not to jam the milk tube
when closing the door.
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution. It is
possible for corrosion to form under-
neath such deposits.
New sponge cloths may contain
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
Clean the beverage outlet, milk tubes
and connecting piece thoroughly.
Specially developed, suitable
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
"Accessories").
F
Using a water filter increases the
intervals until a descaling pro-
gramme needs to be performed.