Publicité
4WD
Front axle plate R
Front axle plate R
5
Ø5 washer
Long nose pliers (not included)
1,2. Adjust the front axle plate R so that the bent end of the steering column is inserted
the hole in the steering linkage as shown.
3. Slide a Ø12 washer onto the steering column from the bent end.
4. Fit the snap ring into the groove in the bent end of the steering column (fig 4-1).
5. Remove the M5x16 machine screw, Ø5 washer and Ø5 lock nut from the steering
linkage. Cut off the plastic tie on the front axle plate L with scissors. Adjust the front
axle plate L and steering linkage to the position as shown. Reinsert the M5x16
machine screw through the hole on the steering linkage, the Ø5 washer and the hole
on the front axle plate L, then fasten the Ø5 lock nut to the opposite end of the screw
with a Long Nose Pliers (Not included).
6. Fit the front gear box to the motor bracket.
( ALL-Wheel Drive )-Attach the Front Axle │ 7a
Front Bottom View
1
M5X16 machine
screw
Ø5 lock nut
Ø5 lock nut
Front axle plate L
Front axle plate L
Steering column
Steering column
Hole in steering
Hole in steering
linkage
linkage
Front gear box
Front gear box
Motor bracket
Motor bracket
2
3
4
4-1
6
Publicité
