Publicité
( Dual-Wheel Drive)-Attach the Front Wheels │ 6b
2WD
HINT: If your product is All Wheel Dirve (4WD), please refer to the page 7a & 7b to attach the front wheels.
5
4
1. Slide a Ø12 washer onto the front axle.
2. Slide a wheel onto the front alxe.
3. Slide another Ø12 washer onto the front axle.
4. Tighten a lock nut to the end of the front axle with a spanner. DO NOT over tighten.
5. "Snap" the hubcap to the wheel.
Repeat the above procedure to assemble the other Front Wheel.
GAP
3
2
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below
picture), if the gap is too big, please add two or three washers
inside the wheel, but after tightening the nut outside the wheel,
please turn the wheel by your finger to check if the wheel can run
smoothly, this is very important, because if the wheel can run
smoothly, it is ok, but if the nut press the wheel and the wheel
can't run smoothly, the motor will be broken easily! Then you need
to decrease one or two washers to make sure the wheel can run
smoothly!
1
Front Bottom View
Publicité
