Publicité
2WD
HINT: If your product is All Wheel Dirve (4WD), please refer to the page 7a & 7b to attach the front wheels.
Front axle plate R
Front axle plate R
5
Ø5 washer
Long nose pliers (not included)
1,2. Adjust the front axle plate R so that the bent end of the steering column is inserted
the hole in the steering linkage as shown.
3. Slide a Ø12 washer onto the steering column from the bent end.
4. Fit the snap ring into the groove in the bent end of the steering column (fig 4-1).
5. Remove the M5x16 machine screw, Ø5 washer and Ø5 lock nut from the steering
linkage. Adjust the front axle plate L and steering linkage to the position as shown.
Reinsert the M5x16 machine screw through the hole on the steering linkage, the Ø5
washer and the hole on the front axle plate L, then fasten the Ø5 lock nut to the
opposite end of the screw with a Long Nose Pliers (Not included).
( Dual-Wheel Drive)-Attach the Front Axle │ 6a
Front Bottom View
1
M5X16 machine
screw
Ø5 lock nut
Ø5 lock nut
Front axle plate L
Front axle plate L
Steering column
Steering column
Hole in steering
Hole in steering
linkage
linkage
2
3
4
4-1
Publicité
