RotoZip Rebel SCS01 Guide De L'utilisateur page 5

Rebel TM Operating Instructions (cont.)
STEP 4: LOCATE THE BUMP-OFF
SLIDE SWITCH AND VARIABLE
SPEED SWITCH
Never leave tool unattended in
WARNING
either the "1" or "2" ON posi-
tions.
he Rebel has 2 variable speeds. The speed is
ontrolled by a three position bump-off slide
witch located on the rear, side of the tool.
Step 4
osition "0" is the OFF position
osition "1" turns the tool ON and operates at
4,000 RPM.
hen the power switch is slid upward to the first
or "1" - position, the tool is "live" with a contin-
ous running action. To turn the tool OFF push
e slide switch to the "0" position.
osition "2" turns the tool ON to the 30,000 RPM
vel with a continuous running action.
o turn the tool OFF, push the slide switch down
the "0" position.
For the best results, when using the Rebel and
p Bits, we recommend using 30,000 RPMs.
Hold the tool with both hands
CAUTION
!
while starting, since torque of
the motor can cause the tool to twist.
Make A Few Practice Cuts
After installing the Zip Bit into the tool and adjust-
ing your depth guide, you should make a few
practice cuts with the tool before attempting an
actual job.
A few exercises will give you the necessary prac-
tice to make clean, professional cuts.
STEP 5:
Make certain that the collet nut is securely tight-
ened before turning the tool on.
STEP 6:
Hold the tool firmly and turn the tool ON to your
desired speed.
IMPORTANT USER TIP
STEP 7:
While holding the tool firmly, insert the Zip Bit into
the material at a 45° angle.
Step 7
Rebel TM Operating Instructions (cont.)
STEP 8:
Slowly bring it to a 90° angle to begin the cut.
The base guide should be flush to the material
surface. For all materials (EXCEPT cutting
around outlet boxes in drywall), steer the tool in
a clockwise direction with slow, steady pressure
to make the cut.
Step 8
STEP 9:
After completing your cut, turn off the tool and
carefully remove it from the material.
Do not attempt to use this tool to make cut-outs
around any fixture or opening which has live elec-
trical wires, or any wall which may have live elec-
trical wiring behind it, as the Zip Bit could conduct
current to the tool, creating an electrocution haz-
ard for the operator. Shut off breakers or remove
fuses to disconnect the circuit. Always hold the
tool by its thermoplastic housing, and always
wear eye protection when operating a Spiral Saw
power tool.
NOTE: Because of the rotating cutting action of
the Zip Bit, there will be a slight pull when cutting.
The slower you cut, the more control you have.
Excessive pressure or fast cutting will cause
excessive heat and may shorten the life of the Zip
Bit.
NOTE: When cutting on a vertical surface, avoid
ending your cut at the bottom of the hole. If pos-
sible, start and end your cut at the top so the
scrap part will not drop onto the rotating Zip Bit.
Turn the tool off and remove it from the material.