Honeywell E3Point Mode D'emploi page 9

Cautions
• The E3Point monitor must be installed only by trained personnel and service
engineers in accordance with local codes.
• The safety of any system incorporating the E3Point monitor is the responsibility
of the assembler of the system.
• Protect the monitor from water, wash-down, and excessive humidity.
• To prevent electrical interference, keep the monitor and wire runs away from
mercury vapor lights, variable speed drives, and radio repeaters.
• Protect the monitor from physical damage (fork lifts, etc.).
• Do not mount the monitor over a door in a refrigerated area.
• For critical locations, more than one monitor should be installed in each room.
• Never mount the sensor flat on a ceiling.
• Never mount the sensor on a vibrating surface.
E Point Gas Monitor Technical Manual
3
Warnings and Cautions
3