Publicité
Get to know your snow blower and its controls. Be sure you (or any other operator) have read and understood the Operation
Precautions listed on page 2 of this manual.
Choke Lever
Primer Button
Ignition Key
The engine operating controls and their functions are as
follows:
Throttle Control Lever − Controls the engine speed.
Choke Control− Use to start a cold engine.
Electric Start Button− Used to start the engine using the
120 volt electric starter.
Prime Button− Used to inject fuel directly into carburetor
manifold to insure fast starts in cool weather.
Ignition Key− Must be inserted to start engine. Pull out to
stop. Do not turn ignition key.
Starter Handle− Starts the engine manually.
The snow blower operating controls and their functions
are as follows:
Speed Shifter Lever − Selects the forward and reverse
speed.
Auger Drive Clutch Lever− Used to engage and disengage
the auger and impeller. To engage push down, to disengage
release.
Traction Drive Clutch Lever− Used to propel snow blower
forward or reverse. Push down to engage, release to
disengage.
1741078
All manuals and user guides at all-guides.com
OPERATION
Gas Fill
Auger Drive
Clutch Lever
Throttle Control
Lever
Electric
Start Button
Starter Handle
Clean-out Tool
ENGINE AND SNOW BLOWER OPERATING CONTROLS
Electric Chute
Speed Shift Lever
Switch
Toolbox
Height Adjust Skid
Discharge Chute − Changes the direction the snow is
thrown.
Remote Chute Deflector Lever − Push remote lever
forward to discharge snow high and far. Pull remote lever
back to discharge snow down.
Electric Chute Switch − Changes the direction of snow
throwing through the discharge chute.
Chute Deflector − Changes the height the snow is thrown.
Height Adjust Skid− Used to adjust ground clearance of
auger housing (see To Adjust Skid Height in the
Adjustment/Repair section of this manual).
Toolbox − Spare shear pins, shear bolt wrenches and
spacers are located in toolbox.
Shear Pin − Shear pins are designed to break (to protect the
machine) if an object becomes lodged in the auger housing.
Drift Cutters − Cuts a path through snow higher than the
auger housing.
Clean-Out Tool − Use the clean-out tool to remove snow and
debirs from the discharge chute and the auger housing.
15
Remote Chute Control
Traction Drive
Clutch Lever
Chute Deflector
Discharge
Chute
Drift Cutter
Auger Housing
Shear Pin
Scraper Bar
Figure 14
Publicité
