Publicité
HOW TO INSTALL
THE SPEED CONTROL ROD
1. Put the speed select lever to the NEUTRAL position.
See Figure 7.
2. Attach the ball joint, located on the bottom end of the
speed control rod, to the shift yoke assembly. See
Figure 8. The fasteners are attached to the ball joint at
the factory.
3. The length ot the ball joint and speed control rod have
been pre−adjusted at the factory. If an adjustment is re-
quired, loosen the nut. Remove the fasteners to discon-
nect the ball joint from the shift yoke assembly. To
lengthen or shorten the speed control rod, turn the
adapter to obtain the correct length.
4. Make sure the speed select lever functions correctly.
Move the speed select lever through all speeds.
REMOTE CHUTE KNOB
1. Assemble the remote chute knob onto the lever until
snug against the nut (see Figure 9).
2. Make sure lip on the remote chute knob is pointed to-
ward the engine.
3. Tighten the nut against the bottom of the remote chute
knob.
1741078
All manuals and user guides at all-guides.com
ASSEMBLY
12
Speed Select Lever
Nut
Shift Yoke
Assembly
Ball Joint
Fasteners
LIp
Nut
Figure 7
Speed Control
Rod
Adapter
Figure 8
Remote Chute
Control Knob
Lever
Figure 9
Publicité
