Publicité
HOW TO ASSEMBLE THE DRIFT CUTTER
Drift cutters are used to cut a path through snow deeper than
the auger housing.
1. Loosen the wingnuts that secure the drift cutters to the
auger housing (see Figure 12).
2. Raise the drift cutters to the desired height.
3. Tighten the wingnuts.
HOW TO SET
THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments
should be necessary. However, after the handles are put in
the operating position, the cables can be too tight or too
loose. If an adjustment is necessary, see "How To Check And
Adjust The Cables" in the Service And Adjustment section.
CHECK THE TIRES
The tires were over inflated for shipment. Check the tire
pressure in the tires. See the sidewall of the tire for the
proper inflation.
NOTE: This snow blower was shipped WITH OIL in the engine. See "Before Starting Engine" in-
structions in the Operation section of this manual before starting engine.
1741078
All manuals and user guides at all-guides.com
ASSEMBLY
IMPORTANT! BEFORE YOU START
OPERATING
r Check the fasteners. Make sure all fasteners are
r On electric start models, the unit was shipped with
14
Drift Cutter
Wingnut
tight.
the starter cord plugged into the engine. Before
operating, unplug the starter cord from the engine.
Figure 13
Publicité
