Publicité
UPPER HANDLE ASSEMBLY
1. Cut tie holding shift rod to lower handle and move shifter
to the neutral position.
2. Loosen, but do not remove the screws, flatwashers, lock-
washers and hex nuts in the upper holes of the lower han-
dle.
3. Remove the fasteners from the lower holes of the lower
handle See Figure 4.
4. Raise upper handle into operating position. Upper han-
dle should be to the outside of the lower handle.
NOTE: Make sure the cables are not caught between
the upper and lower handle.
NOTE: If the cables have become disconnected form
the drive levers, reinstall the cables as shown in
Figure 5.
5. Install the fasteners that were removed in step 3. DO
NOT tighten until all bolts are in place.
6. Tighten all handle bolts.
CHECK THE CABLES
1. If control cables have become unattached from motor
mount frame, reconnect cables as shown in Figure 6.
Traction Drive Cable
1741078
All manuals and user guides at all-guides.com
ASSEMBLY
Auger Drive Cable
Figure 6
Lockwasher
"Z" Fitting
Control Cable
11
Bolt
Nut
Flatwasher
Figure 4
Lever
Figure 5
Publicité
