Publicité
HOW TO INSTALL
THE SPEED SELECT KNOB
1. Assemble the speed select knob onto the speed select
lever until snug against the nut (see Figure 10).
2. Make sure lip on the speed select knob is pointed to-
ward the engine.
3. Tighten the nut against the bottom of the speed select
knob.
SNOW CHUTE ASSEMBLY
1. Position the snow chute to the INSIDE of the snow
chute flange. Align the three holes in the snow
chute with holes in snow chute flange (see Figure 11).
2. Place three 5/16-18 carriage bolts from the inside of
the chute as shown in figure 11 (hardware is found
in parts bag).
3. Place three 5/16-18 flat washers and three 5/16-18
nuts on the outside of the flange.
4. First tighten the rear carriage bolt, then tighten the
remaining two carriage bolts. Make sure all carriage
bolts are tight.
5. Attach the remote snow chute deflector cable to the
weld stud (on deflector) and secure in place using
a pushnut as shown in Figure 12 (pushnut is found
in hardware bag).
NOTE: Before starting step 6 make sure that the chute
deflector is in the full open position and the remote
chute lever is in the full open position.
.
6. Attach the remote snow chute deflector cable
the cable chute bracket (see Figure 12) and secure
by tightening nuts (on cable) to the cable chute
bracket.
NOTE: check all carriage bolts in flange for tightness.
DO NOT overtighten.
1741078
All manuals and user guides at all-guides.com
ASSEMBLY
13
Snow Chute Extension
Carriage Bolt
Flange
Figure 11
Snow Chute Deflector Cable
Pushnut
Snow Chute Deflector
Snow Chute Deflector Cable
Figure 12
Speed Select
Knob
Nut
Speed Select Lever
Figure 10
Flat Washer
Nut
Weld Stud
Cable Chute Bracket
Nuts
Publicité
