Publicité
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction "A".
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
NOTES
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment
from them.
We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 playback hours)
TIPS FOR BETTER TURNTABLE PERFORMANCE
1. When opening or closing the turntable cover, handle it gently, gripping it either at the
centre or at each side.
2. Do not touch the needle tip with your fingers; avoid bumping the needle against the
turntable platter or record edge.
3. Frequently clean the needle tip-use a soft brush in a "back-to-front" motion only.
4. If you must use a needle cleaning fluid, use very sparingly.
5. Gently wipe the turntable player housing with a soft cloth. Use only a small amount of
mild detergent to clean the turntable player.
6. Never apply harsh chemicals or solvents to any part of the turntable system.
SPECIFICATIONS
Type
All manuals and user guides at all-guides.com
Belt drive
10
Guide Pins (inside)
Publicité
