Publicité
8.2 Handling
Please handle the product carefully. Impact, shocks or a fall even from a low
height can damage the product.
To prevent an electric shock, do not touch the measuring points when taking
measurements, either directly or indirectly. When taking measurements, do not
touch any area beyond the grip markings on the probe tips.
8.3 Operating environment
Do not expose the product to any mechanical stress.
Protect the product from extreme temperatures, strong jolts, flammable gases,
vapours, and solvents.
Protect the product from high humidity and moisture.
The product must not be exposed to direct sunlight.
Never switch the product on immediately after taking it from a cold into a warm
environment. This may cause condensation to form, which can destroy the prod-
uct. Allow the product to reach room temperature before using it.
Do not use the device shortly before or after a thunderstorm (lightning! /high-
power surges!). Ensure that your hands, shoes, clothes, the floor, circuit and
circuit components are dry.
Avoid operation near strong magnetic or electromagnetic fields, transmitter aeri-
als or HF generators. Otherwise, the product may not function properly.
8.4 Operation
Consult an expert when in doubt about the operation, safety or connection of
the device.
For installations in industrial facilities, follow the accident prevention regulations
for electrical systems and equipment issued by the national safety organisation
or the corresponding national authority.
In schools, educational facilities, and hobby and DIY workshops, meters must
be used under the responsible supervision of qualified personnel. The same
applies when the meter is used by people with reduced physical and mental
capabilities.
Always ensure that the multimeter is set to the correct measurement mode be-
52
Publicité
