Publicité
V1.2
1,000 LB HYDRAULIC/PNEUMATIC MOTORCYCLE LIFT
NOTICE! Never use a penetrating oil to lubricate the pump.
Penetrating oil acts as a solvent that will dissolve the pump's
grease packing and may damage the o-rings, causing the
pump to seize or malfunction.
1.
Manually add a drop or two of air tool oil into the tool's
male connector before each use and after every hour of
continuous use. Attach the air source and operate for three
seconds to distribute the oil. The tool will not work
properly without lubrication and parts will wear
prematurely.
2.
Avoid adding too much air tool oil as this can cause
premature power loss and eventual tool failure. A qualified
technician will need to take the tool apart and clean out the
excess oil.
BLEEDING THE HYDRAULIC SYSTEM
Bleed excess air from the hydraulic system as follows:
1.
Open the release valve by depressing the pressure release
pedal (J).
2.
Remove the oil filler plug and fill the pump with hydraulic
fluid.
3.
Wait 5 minutes for trapped air to rise to the surface.
4.
Pump the foot pedal (K) quickly for several full strokes to
eliminate any air in the system. Keep the release valve open.
5.
Check the oil filler hole and if necessary, top off with more
hydraulic oil.
6.
Restore the oil filler plug. Close the release valve by
restoring the pressure release pedal (J) to its original
position.
7.
Test the ram several times for proper operation before
putting it into use. Do not use the ram if it still does not
appear to be working properly. Have a qualified service
technician service or repair the hydraulic system.
Visit www.princessauto.com for more information
8667784
11
Publicité
