Kicker PXIBT100.2 Manuel D'utilisation page 3

The remote bar mounting clamp may be installed to either the left or right side on the back of the remote.
Use the included remote mounting plate to perform a custom, fl ush installation of the remote. Be careful
not to drill into wiring or vehicle mechanisms. You are solely responsible for safely and securely mounting
the unit and remote. Use the cut-out template below to assist in the installation.
1m cable
Use the included 1.5m
remote extension cable if
necessary
Height:
41mm
2016 PXiBT100.2 Rev G.indd 3 2016 PXiBT100.2 Rev G.indd 3
Width: 86mm
Depth: 18mm
3
12/8/2015 11:35:28 AM 12/8/2015 11:35:28 AM