When you fit the hedge cutter blade
check the position of the pin for the eccentric connector (Fig. 5/Item 1). Take the
hedge cutter blade and slide the eccentric mount (Fig. 6/Item 1) into position so
that the pin for the eccentric connector and the eccentric mount fit together pre-
cisely when assembled. Slot the hedge cutter blade onto the guide pins (Fig. 5/
Item 2).
When you fit the grass cutter blade
check the position of the pin for the eccentric connector (Fig. 5/Item 1) again. Shift
the eccentric mount (Fig. 7/Item 1) on the grass cutter blade to the left or the right
to find the position at which the pin for the eccentric connector (Fig. 5/Item 1) and
the eccentric mount (Fig. 7/Item 1) match up.
6
8. CLEANING, MAINTENANCE AND ORDERING OF SPARE
PARTS
8.1 Cleaning
•
Keep all safety devices, air vents and the motor housing free of dirt and dust
as far as possible. Wipe the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
•
We recommend that you clean the device immediately each time you have fini-
shed using it.
•
Clean the equipment regularly with a moist cloth and some soft soap. Do not
use cleaning agents
equipment. Ensure that no water can seep into the device.
•
A few drops of oil (e.g. sewing machine oil) will improve the cutting perfor-
mance of the blades, but never apply any grease to the blades.
Anl_AGS_10_8_Li.indd 82
Anl_AGS_10_8_Li.indd 82
1
or solvents; these could attack the plastic parts of the
7
1
02.12.15 13:33
02.12.15 13:33