Safety Regulations - Ayce AGS 10,8 LI 100-190 Mode D'emploi D'origine

•
The vibration emission level has been measured in accordance with a set of
standardized criteria and can be used to compare one power tool with another.
•
The specified emission level can also be used to make an initial assessment of
the exposure to vibrations.
•
The vibration emission level may vary from the level specified during actual
use, depending on the way in which the power tool is used.
•
Try to keep the impact from vibrations as low as possible. Exposure to vibra-
tions can be reduced by wearing gloves when using the tool, for example, and
by limiting the amount of operating time. This includes the full cycle of opera-
tion (e.g. times when the power tool is switched off and times when the tool is
switched on but no working load is applied).

3. SAFETY REGULATIONS

Danger!
When using the equipment, a few safety precautions must be observed to avoid
injuries and damage. Please read the complete operating instructions and safety
regulations with due care. Keep this manual in a safe place, so that the informa-
tion is available at all times. If you give the equipment to any other person, hand
over these operating instructions and safety regulations as well. We cannot accept
any liability for damage or accidents which arise due to a failure to follow these
instructions and the safety instructions.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regulations and instructions may result in
an electric shock, fire and/or serious injury.
Keep all safety regulations and instructions in a safe place for future use.
Anl_AGS_10_8_Li.indd 68 Anl_AGS_10_8_Li.indd 68 02.12.15 13:32 02.12.15 13:32