Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
Electrical connection
The electrical connections must be carried out by a
certified electrician in accordance with all the national
regulations.
Observe the enclosed wiring diagram.
Before installation, make sure that the voltage and
frequency listed on the data plate correspond with
the site's electrical supply.
If the appliance is hard wired, a multiple-pole
separator must be installed. Separators with a
contact gap of more than 1/8" (3 mm) are valid as
separators. All components have to bear CSA or UL
approval.
The plug connection or the separator must be
accessible at all times.
You must be able to lock the separator or monitor it at
all times in case the appliance has to be
disconnected from the power supply.
When the dryer has been connected, check the
rotation direction of the fan. It must turn clockwise. If it
turns counter clockwise, two phases must be
exchanged at the terminal box.
Potential equalization
A potential equalization must be provided if the leak
current is >10 mA.
36
Air intake / Venting
Only operate the dryer if it is connected to proper
venting ductwork, and there is sufficient air
ventilation.
See the enclosed installation instructions.
Steam connection
The steam connection must be carried out by a
certified installer.
Observe the enclosed installation instructions.
The steam valve and the condensate trap are
available from Miele.
Publicité
Chapitres
Table des Matières
