Publicité
8.2
P2: Area input
8.3
P2: Diameter
Fig. 22: Setting mode - Diameter
8.4
P2: Length, width
Switch as described under 8.1 to parameter
•
P1, area (A) and confirm with the REC button.
You are now in the P2 setting mode.
•
The setting range is 0 - 9999 cm
Press the SET button to enter the setting
•
mode.
Press the ▼ or ▲ button to make the setting.
•
Press the AVG button to jump from one deci-
•
mal point to the next during the setting.
Press the SET button to accept the set value.
•
•
Press the REC button until you are back in P1
mode.
Press the SET button to switch to the diameter
•
parameter (D) and confirm with the REC but-
ton.
Press the SET button to enter the setting
•
mode.
The adjustment range is 0 - 99 cm.
Press the ▼ or ▲ button to make the setting.
•
Press the AVG button to jump from one deci-
•
mal point to the next during the setting.
Press the SET button to accept the set value.
•
•
Press the REC button until you are back in P1
mode.
Press the SET button to switch to the Length
•
Width (S/W) parameter and confirm with the
REC button.
Press the SET button to enter the setting
•
mode.
The adjustment range is 0 - 99 cm.
•
Press the ▼ or ▲ button to make the setting.
Press the AVG button to jump from one deci-
•
mal point to the next during the setting.
Press the SET button to accept the set value.
•
You are now in the mode for setting the width.
•
Proceed in the same way here.
Setting mode
2
41
Publicité
