Publicité
Setting mode
8
Setting mode
8.1
P1: Pipe dimensions
Fig. 21: Setting mode - pipe dimensions
40
To access the setting mode, press and hold
•
the SET button for longer than 5 seconds
while the appliance is switched on.
Press the ▼ or ▲ button to select a parame-
•
ter (P1 - P4)
Press the SET button to call up the selected
•
parameter.
•
Press the SET button again to switch between
the options.
•
Press the REC button to confirm. The device
now switches to the next parameter (P1 - P4).
To exit the setting mode and return to normal
•
measuring mode, press the ESC button.
Press the ▼ or ▲ button to select P1 (if not
•
already selected):
The following input options are available:
-
Diameter (D)
-
Area (A/Area)
-
Length*Width (LW/Lingth.Width)
•
Press the SET button to switch between the
diameter (D), area (A/Area) and length*width
(LW) parameters.
Press the Rec button to select the desired
•
parameter.
Press the SET button to set the parameter.
•
Press the ▼ or ▲ button to set the value
•
Press the SET button to go to the next setting
•
mode P2
Publicité
