Bestway Flowclear 58515 Manuel De L'utilisateur page 4

PRODUCT DESCRIPTIONS
270mm
311mm
PARTS & TOOLS NEEDED
Compare the parts in your box to the parts listed in this manual. Verify that the equipment
components represent the model that you had intended to purchase. If any parts are damaged
or missing at the time of purchase, visit our website bestwaycorp.com/support.
Before assembling the sand filter, take a few minutes to become familiar with all the sand filter parts.
You will need a screwdriver (not included).
SETUP INSTRUCTIONS
Overview
1. The sand filter should be placed on solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and Control Valve are
accessible for operation, servicing and winterizing.
2. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed
on ground or a certain pedestal made of wood or concrete before use to
prevent the sand filter from accidentally falling. Fully assembled sand filter
will exceed 18 kg. The mounting holes should be 8 mm in diameter and
spaced 285 mm apart. Use two bolts and nuts with a maximum of 8 mm
in diameter to fasten the sand filter to the pedestal.
Assembly Instructions
For installation instructions, scan the QR code printed on the front cover or follow the illustrations inside the
manual. Drawings are for illustration purposes only. May not reflect actual product. Not to scale. Bestway
is not responsible for damage caused to the product due to mishandling or failure to follow these instructions.
Helpful Installation Tips:
IMPORTANT: Do not dry run the sand filter. Make sure both the pool's inlet and outlet are open and fully
covered by water. Before switching on the sand filter, perform the air discharging operation as shown.
AIR DISCHARGING OPERATION: Follow these steps to discharge air before switching the sand filter on
and after every maintenance operation. Omitting this operation will greatly affect the lifespan of the product.
NOTE: It is important to repeat this operation every time you start the pump after winterizing, any maintenance
and backwashing the sand bed.
Filter Diameter:
Effective Filter Area:
Max. Operating Pressure:
Working sand filter pressure:
Max. Water Temperature:
Use with:
#20 silica Sand (0.45-0.85 mm)
Capacity:
Polysphere™ Pool Filtration Balls
Capacity:
NOTE: If #20 silica Sand (0.45-0.85 mm) / Polysphere™ Pool
Filtration Balls is not included in the set, please visit the website
www.bestwaycorp.com.
4
270 mm
0.059 m (0.635 ft )
2 2
0.42 Bar (6 PSI)
<0.25 Bar (3.5 PSI)
35°C (95ºF)
#20 silica Sand (0.45-0.85 mm) /
Polysphere™ Pool Filtration Balls
Approximately 8.5 kg (18.7 lbs)
Approximately 240 g (0.53 lbs)
285mm
Φ8mm