Publicité
LED indicator / Beeper
Led indicator / Beeper on the tool shows the following functions.
Function
This function works when the tool has
reached the preset fastening torque
Auto-stop
and normal tightening has been com-
fastening
pleted. This helps overtightening to be
avoided.
For approximately one second after
Delayed re-start
auto-stop fastening, the tool does not
start even if the switch trigger is pulled.
Insufficient fastening has been per-
Warning against
formed when the switch trigger has
insufficient fasten-
released before reaching the preset fas-
ing
tening torque.
Warning for bat-
This indicates the appropriate time to
tery cartridge
replace the battery cartridge when the
capacity
battery power becomes low.
Checking the
This function works when the battery
remaining battery
power is almost used up. At this time,
capacity,
tool stops immediately.
Auto-stop
This function works to check the proper
Check the LED
operation of the LED indicator, light
indicator, light and
and beeper when a battery cartridge
beeper operation
has been inserted into the tool.
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason and the tool stops.
This function works if the temperature
Overheat
of the controller or motor increases to a
high level and the tool stops.
This function works to avoid the tool's
Operation error of
immediate start upon insertion of bat-
the switch trigger
tery cartridge into the tool with the
switch trigger being pulled.
This indicates the abnormal condition of
Motor malfunction
the motor. The tool does not operate.
6
All manuals and user guides at all-guides.com
Status
LED indicator
Lights up in
green for
approximately
one second.
Lights up in
red.
Flickers in red
slowly.
Lights up in
red.
Lights up first
in green, next
red. (And then
the light
comes on.)
Flickers in red
and green
alternatively.
Flickers in red
quickly.
Flickers in red
and green
alternatively.
Flickers in red
and green
alternatively.
Status of
the LED indicator/beeper
Beeper
__
A long beep
A series of
long beeps
A long beep
A series of
very short
beeps
A series of
short beeps
A series of
short beeps
A series of
short beeps
A series of
short beeps
Action to be taken
__
Retighten the screw.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
__
Replace the battery
with fully charged
one.
Remove the battery
cartridge immedi-
ately and cool the tool
down.
Release the switch
trigger.
Ask Makita service
centers.
Publicité
