5=
Using an adjustable wrench, hold the nut on the plastic water
line to keep it from moving. Then, with a second wrench turn
the compression
nut on the copper tubing counterclockwise
to completely
tighten. Do not overtighten.
A. Plastic water line
B. Water valve inlet port
C. Compression
nut
D. Copper tubing
E. "P" clamp
6. Check connection by pulling on copper tubing. Attach copper
tubing to refrigerator cabinet with a "P" clamp. Turn on water
supply to refrigerator and check for leaks. Correct any leaks.
Complete
the Installation
Electrical Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to
completely fill the ice container.
Remove the Base Grille
1. Grasp the grille with both hands.
2. Pull the grille toward you.
Replace the Base Grille
1. See the markings on the inside of the base grille for proper
placement.
2. Align the grille mounting clips with the cabinet slots.
3. Push the grille firmly into the cabinet slots until it snaps into
place.
Graphics are included later in this section.
Remove
and Replace
Handles
1. Using a 3/32"Allen wrench, loosen the two set screws located
on the side of each handle. See Graphics 1 and 2.
2. Pull the handle straight out from the door. Make sure you
keep the screws for reattaching
the handles.
3. To replace the handles, reverse the directions.
Remove
Doors and Hinges
Electrical Shock Hazard
Disconnect power before removing
doors.
Failure to do so can result
in death or electrical
shock.
IM PORTANT:
•
Remove food and any adjustable door or utility bins from
doors.
•
All graphics referenced in the following instructions
are
included later in this section after "Final Steps."
TOOLS NEEDED: 5/le", 3/8",1/4"hex-head socket wrench,
#2 Phillips screwdriver, and a flat-blade screwdriver.